PMRV-50 GEARBOX FOR ELECTRIC MOTOR MS80 (0.55-0.75KW) RATIO 10:1

Additional description:

Description:

PMRV gearboxes are used in combination with electric motors.

The gearbox reduces the revolutions of the electric motor to the value we want to operate with. Gearboxes have different ratios 7.5:1 - 10:1 - 20:1 - 40:1.

When installing the gearbox, always ensure that:

• the data on the nameplate matches the data of the ordered item
• the housing and shafts are clean and undamaged
• the surface to which the gearbox is attached is flat and strong enough
• the gearbox and the electric motor shaft fit well
• if there is a possibility of vibrations or jamming, a torque limiter must be installed
• rotating parts are covered with plastic covers
• the device used outdoors must be adequately weather protected
• operating conditions do not cause corrosion (unless previously agreed and the gearbox and electric motor are properly prepared)
• gears, gear shafts, input/output shafts are properly secured to avoid radial or axial loads that do not exceed the maximum allowable limit
• all couplings are coated with anti-corrosion material to prevent oxidation upon contact
• all fastening screws must be securely tightened

All calculations are based on electric motors with 1400 revolutions. If you are using an electric motor with a different speed than 1400 revolutions per minute, divide the input revolutions by the gearbox ratio to get the output revolutions.

More technical data can be found in the attachment 'DIMENSIONS - DATASHEET'.